Table of Contents
Advertisement
DP
E™ Power System User Manual
O
Table 2: DP
PANDUIT Part Number
DPOEPWRB120Y
DPOEPWRCU
DPOEPWRR500
DPOEPWRR1250
DPOEPWRF7.5
DPOEPWRF5
CORD-A
CORD-E
CORD-S15
CORD-J15
CORD-U
Heat Dissipation
The following table displays the maximum and typical British Thermal Units per hour (BTU/hr) of heat
dissipated from each rectifier. The maximum is calculated at 90 VAC, and typical is calculated at 230
VAC.
Part Number
DPoEPWRR500
DPoEPWRR1250
AC Input Wiring
The DP
E™ Power System chassis uses an individual AC feed architecture (See
O
Figure 2: Individual AC Feed Wiring
AC connections are made using the IEC320 receptacles on the rear of the chassis (See
Figure 8: Chassis (Rear View) - AC
Connect each feed, using the appropriate power cord as listed in
Available into the appropriate receptacle on the back of the system. Cord securing brackets are included
to secure the AC plugs to the chassis (See
E™ Power Components Available from PANDUIT
O
Description
Individual power supply - 120 watt power supply –
48 volt output
Unmanaged power chassis (supports 3 rectifiers)
500 watt rectifier for use in power chassis
1250 watt rectifier for use in power chassis
7.5 amp fuse (package of 8)
5 amp fuse (package of 4)
Power cord for Australia
Power cord for Europe
Power cord for North America
Power Cord for Japan
Power cord for the U.K.
Table 3: Heat Dissipation
Typical BTU/hr
Architecture), which requires one AC feed per rectifier. Up to three,
Connections).
Figure 9: Securing Cord Bracket to
249
451
Table 2: DPoE™
3
Part Number: PN380C
Max BTU/hr
410
833
Power Components
Chassis).
Advertisement
Table of Contents
