Table of Contents
Advertisement
DP
E™ Power System User Manual
O
POWER PLANT MOUNTING AND WIRING
WARNING:
Ensure all AC and DC power sources are off and disconnected.
Mechanical Mounting
The DP
E™ Power System chassis is installed in a standard EIA 19" rack. It is recommended that one
O
person lift the chassis into the proper rack place while another person installs the supplied mounting
screws. Tighten the screws with a torque wrench to the setting according to
Torque
Settings.
Support Shelf Mounting (Optional)
After securing the DP
E™ Power System chassis with mounting screws in the front, an optional rack
O
mount shelf may be installed underneath the chassis on the backside of the rack to alleviate potential
sagging of the chassis unit, due to weight distribution when mounted on a 2-post rack. PANDUIT offers a
1RU shelf (part # SRM19FM1) with a load rating of 30 lbs that will help support the chassis. For optimum
saftety, a 2 RU shelf (PANDUIT part # SRM19FM2 – shown below) with a load rating of up to 50 lbs may
be installed.
Attach power chassis to front of rack
using Mounting Brackets
Optional Rack Mount Shelf
(attached to back of rack with
shelf turned upside down)
NOTE:
Optional rack shelf is actually installed upside down to the rear of the rack to allow
power chassis to rest on the flat side of the shelf.
Mounting Brackets
Slots for Rectifiers
Figure 5: Chassis (Front View)
Figure 6: Optional Rack Mount Shelf
8
Part Number: PN380C
Table 6: Recommended
In shelf
distribution
Advertisement
Table of Contents
