Ac Input; Dc Output; Figure 7: Cord Bracket; Figure 8: Chassis (Rear View) - Ac Connections - Panduit DPOE PN380C User Manual

DP E™ Power System User Manual
O

AC Input

Slip the cord bracket around each cord (PANDUIT part # CORD-****), as shown in
Bracket. Plug the cord into the proper receptacle on the back of the chassis (See
Figure 8: Chassis (Rear View) - AC
provided screws (See Figure 9: Securing Cord Bracket to
Securing
Screw

Figure 8: Chassis (Rear View) - AC Connections

DC Output

DC connections are accomplished via the rear terminal blocks and bulk output connection as shown in
Figure 12: Chassis (Rear View) - DC
rear compression screw terminal block that will accept wires sizes up to 12 AWG. If a fuse is not in
corresponding slot, then place wire in output and corresponding return, and compress the screws to 4 in-
lbs. Place a fuse into the corresponding position into the fuse holder as shown in
(Front View) - GMT fuse
Connections), then secure the cord bracket to the chassis using the

Figure 7: Cord Bracket

#4-40 Screws

Figure 9: Securing Cord Bracket to Chassis

Connections. GMT-fused connections are accomplished via the
holder.
Chassis).
9
Part Number: PN380C
Figure 7: Cord
Cord
Bracket
Figure 10: Chassis