Maintenance And Storage; Contents Of Parts Bag - Craftsman 536.886122 Operating Instructions Manual

electric
start kits, etc.)°
19. Never operate the snow thrower
"without good visibility or light. Always be
sure of your footing, and keep a firm
hold on the handles. Walk; never run.
MAINTENANCE AND STORAGE
.
Check shear bolts and other bolts
frequently for proper tightness to be
sure the snow thrower is in safe working
condition.
2. Never store the snow thrower with fuel
in the fuel tank inside a building where
ignition sources are present Such as hot
water and space heaters, clothes
dryers, and the like. Allow the engine to
cool before storing in any enclosure.
3. Always refer to operator's manual
instructions for important details if the
snow thrower is to be stored for an
extended period.
4. Maintain or replace safety and instruc-
tion labels, as necessary°
5. Run the snow thrower a few minutes
after throwing snow to prevent freeze-
up of the auger/impeller.
\ WARNING; The engine exhaust
from this product contains chemicals
known to the State of California to cause
cancer, birth defects or other reproductive
tlarm.
/_ WARNING: This snow thrower is for
use on sidewalks, driveways and other
ground level surfaces.
Caution should be exercised while using on
steep sloping surfaces. DO NOT USE
SNOW THROWER ON SURFACES
ABOVE GROUND LEVEL such as roofs of
residences, garages, porches or other such
structures or buildings.
Contents of Parts Bag (actual size)
1 - Owner's Manual (not shown)
2 - Parts Bags (not shown)
*Non-Assembly Parts
(1/4-20 x 1-3/4 In.)
DG
1- Nut, 5/16-18 Reghex
*2 - Spare Spacers
1-Nut, 1/2-13 Hexjam
*2 - Spare 1/4-20 Hex Nuts
1- Shifter Knob I _-_ }
1 -Washer_ Hvsptlk
1 - Starter Motor Cord 10Ft.
3 -Carriage Bolts, 5/16-18xl .00 In.
DG
3 -Hex Nylon Nuts, 5/16-18
4
4 - Flatwashers 11/32 In.
1- Screw, 5!16-18 x 2 In.