TROUBLESHOOTING
PROBLEM
i LossoLppwer(cent'd)
Excessivevibration
Enginecontinuesto
run whenoperator
leaves seat with at
tachmentclutch
engaged
Poorcut- uneven
Mower blades will not
rotate
Poor grass discharge
CHART
CAUSE
•
Faulty spark plug.
•
Dirty fuel filter.
Stale or dirty fuel.
• Water in fuel.
• Spark plugwire loose.
•
Dirty engine air screen/fine.
•
Dirty/clogged muffler.
•
Loose or damaged widng.
•
Carburetor out of adjustment.
•
Engine valves out of adjust-
ment.
• Worn, bent or loose Made.
•
Bent blade mandrel.
•
Loose/damaged pad(s),
• Faultyoparator-safety pres-
ence controlsystem.
• Worn, bent or loose blade.
•
Mower deck not level.
• Buildup of grass, leaves, _nd
trash under mower.
• Bent blade mandrel.
• Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
• _Obstruction in dutch mecha-
nism.
•
Worn/damaged mower ddve
belt. "-
• Frozen idler pulley.
• Frozen blade mandrel.
• Engine speed too slow.
• Travel speed toofesL
• Wet grass.
•
Mower deck not level.
• Low/uneven tire air pressure.
• Worn, bent or looseblade.
i
CORRECTION
• Clean and regap or change
spark plug.
• Replace fuel filter.
• Drain fuel tank and refill with
fresh gasoline.
•
Drain fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
•
Connect and tighten spark plug
wire.
• Clean engine air scmon/fins.
• Clean/replace muffler.
• Check all widng.
• See "To Adjust Carburetor" in
Serv_eandAdjustments
section.
• Contact an authorized eervice
center.
•
Replace blade.
Tighten blade
boll
•
Replace blade mandrel.
• Tighten iooea part(s). Replace
damaged parts.
• Check w i_ng, s w_chee andcon-
nections. If not corrected, contact
an authorized service
center/department.
• Replace blade. Tighten blade
boll
• Level mower deck.
• Clean underside of mower hous-
ing.
•
Replace blade mandrel.
• Clean around mandrels to open
vent .holes.
• Remove obstruction.
• Replace mowerdrive bell
• Replaceidler pulley,
• Replaceblade mandrel.
•
Place throttle control in "FAST"
pomon.
•
Shift to slower speed.
•
Allow grass to d_J before mow-
ing.
• Level mower deck.
• Check tires for proper air pres-
sure.
•
Replace/sharpen blade. Tighten
blade bolt.
31