Mulching Plug - Honda HRC216PDA Owner's Manual

Mulching Plug

To mulch the grass clippings
rather than bag them, install
the mulching plug.
1. Stop the engine.
2. Raise the discharge
guard.
3. Remove the grass bag.
4. Insert the mulching plug
into the discharge chute
at the back of the
mower.
Make sure the tab at the bottom rear of the mulching plug fits
snugly into the slot at the back of the discharge chute.
Cutting Height
To adjust cutting height, pull each adjustment lever toward the wheel,
and move it into another notch. Move all four adjustment levers to the
same height setting.
If you are not sure what cutting height to select, start with a high setting
and check the appearance of the lawn after mowing a small area. Then
readjust cutting height if necessary.
REAR WHEEL
BEFORE OPERATION
4 in (101 mm)
3-1/2 in (89 mm)
3 in (76 mm)
2-1/2 in (63 mm)
2 in (51 mm)
1-1/2 in (39 mm)
1 in (25 mm)
3/4 in (19 mm)
SLOT
TAB
FRONT WHEEL
15