Advertisement
KNOW
YOUR SAW
See Figure 1.
Before attempting to use your saw, familiarize yourself
with all operating features and safety requirements.
ELECTRICAL
CONNECTION
Your saw has a precision built electric motor. It should
be connected to a power supply that is 120 volts, 60
Hz, AC only (normal household current). Do not
operate this tool on direct current (DC). A substantial
voltage drop will cause a loss of power and
overheating. If your tool does not operate when
plugged into an outlet, double-check the power supply.
LOCK-ONBUTTON
CHIP SHIELD
A clear plastic chip shield is installed on the front of
your saw for protection against flying dust and chips.
The flip-up design of the chip shield makes installing
and removing blades easier. For your protection,
do
not use saw without chip shield properly
in place.
APPLICATIONS
(Use only for the purpose
listed below)
•
Cutting wood surfaces.
•
Cutting thin sheet metal.
•
Cutting plastics and laminates.
VARIABLE SPEED
CONTROLSELECTOR
SWITCH
TRIGGER
CHIP
SHIELD
(_
ORBITAL
BASE
BLADESTORAGE
AREA
HEX KEY
STORAGEAREA
VACUUMATTACHMENT
Fig. 1
,_
WARNING:
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of
a second is sufficient to inflict severe injury.
7
Advertisement
