Advertisement
DUSTLESS
FEATURE
See Figures 12 and 13.
For dustless operation, a vacuum attachment has
been provided with your saw. It attaches to the saw
base.
TO INSTALL:
•
Unplug your saw.
_IL
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious injury.
•
Remove
blade
from saw.
•
Using the 1/8 in. hex key provided, loosen the base
pivot screws and slide clamp plate forward. See
Figure 12.
Note: This position is for vacuum attachment use
only. Sliding the clamp plate forward, covers the
dust blower chute and allows sawdust and chips to
be pulled back through the vacuum attachment.
•
Using the 1/8 in. hex key provided, tighten the
base pivot screws.
•
Remove hex key and return it to storage area.
BASEPIVOTSCREWS
CLAMP PLATE
•
Place front of saw base under the tabs located on
front of vacuum attachment and press to snap on.
See Figure 13.
BASE
EXHAUST
OPENING
TAB
VACUUM
TABS
ATTACHMENT
Fig. 13
CLAMPPLATESHOULDONLYBE
IN THISPOSITIONWHENVACUUM
ATTACHMENT IS IN USE
1/8 in. HEXKEY
BASE
Fig. 12
•
Replace blade.
•
Connect exhaust opening to dust collection system.
TO REMOVE:
•
Unplug your saw.
_i,
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious injury.
•
Remove blade from saw.
•
Spread tabs located on the rear of the attachment
then remove attachment from base.
•
Using the 1/8 in. hex key provided, loosen the base
pivot screws and slide clamp plate to the rear.
Note: After removing vacuum attachment, clamp
plate must be slid back to the rear for normal
operating position. This allows the air to flow out
around the blade blowing sawdust and chips away
from the operators view of the line of cut.
13
Advertisement
