Craftsman 973.111400 Owner's Manual page 11

Note: Remember the two-speed feature (HI-LO) when
setting torque. The amount of torque will vary depend-
ing on which speed setting you have your drill-driver.
Switching to LO speed will increase torque. Switching
to HI speed will decrease torque.
BIT STORAGE
See Figure 11.
When not in use, bits provided with your drill can be
placed in the storage area located on the top of your
drill as shown in Figure 11.
SCREWDRIVER BITS
DRILLING
See Figure 13.
BIT STORAGE AREA
Fig, 11
_11 WARNING: Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to de so could result In objects
being thrown into your eyes, resu[ting in possible
serious injury.
LEYEL DRILLING ,_
See Figure 12
A convenient new feature provided with your drill is a
]evel. It Js recessed in the motor housing on top of
your drill. It can be used to keep drill bits level during
drilling operations.
LEVEL
Fig. 12
Fig, 13
When drilling hard smooth surfaces use a center
punch to mark desired hole location. This will prevent
the drill bit from slipping off center as the hole is
started. However, the low speed feature allows
starting holes without center punching tf desired. To
accomplish this, simpty operate your drill at a low
speed until the hole is started,
The material to be drilled should be secured in a vise
or with clamps to keep it from turning as the drill bit
rotates.
Hold tool firmly and place the bit at the point to be
drilled, Depress the switch trigger to start tool.
Move the drill bit into the werkpJece applying only
enough pressure to keep the bit cutting. Do not force
or apply side pressure to elongate a hole.
,_ WARNING; Be prepared far binding or bit
breakthrough. When these situations occur, drill
has a tendency to grab and kick opposite to the
direction of rotation and could cause loss of
control when breaking through material. If not
prepared, this loss of control can result in
possible serious injury.
_/hen drilling metals, use e light oil on the drill bit to
keep it from overheating. The oil will prolong the life of
the bit and increase the drilling action.
If the bit jams in workpiece or if the drill stalls, release
switch trigger immediately. Remove the bit from the
workpiece and determine the reason for jamming.
11