Download Print this page

Craftsman 917.272030 Owner's Manual page 25

18.5 hp electric start 46" mower 6 speed transaxle lawn tractor

Advertisement

TO REPLACEMOWERBLADE DRIVE
BELT
Parkthe tractoron level surface. Engage
parkingbrake.
• Remove mower drive belt (See "TO
REPLACE
MOWER
DRIVE
BELT" in
this section of this manual).
• Remove mower (See ='1"OREMOVE
MOWER" in this section of this manual).
• Remove four screws from right hand
mandrel
cover and remove cover.
Unhook spring from bolt on mower
housing.
• Carefully roll belt off right hand mandrel
pulley.
• Remove belt from center mandrel pul-
ley, idler pulley, and left hand mandrel
pulley.
• Remove any dirt or grass which may
have accumulated
around mandrels
and entire upper deck surface.
• Check secondary idler arm and idler to
see that they rotate freely.
• Be sure spring is hooked in secondary
idler arm and sway-bar bracket.
• Install new belt in lower groove of left
hand mandrel pulley, idler pulley, and
center mandrel pulley as shown.
• Roll belt over right hand mandrel pulley.
Make sure belt is in all grooves properly.
• Reconnect
spring to bolt in mower
housing and reinstall right hand mandrel
cover.
• Reinstall mower to tractor (See
UlNSTALL MOWER
AND DRIVE BELT"
in the Assembly section of this manual).
• Reassemble
mower ddve belt (See TO
REPLACE
MOWER
DRIVE BELT" in
this section of this manual).
Left Hand
Mower Blade
Center
Drive Belt
Mandrel
Idler
Right Hand
Mandrel
Secondary
Idler Arm
Spring
Bracket
Screw
TO ADJUST
BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
right side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed
in high-
est gear, then brake must be adjusted.
• Depress clutch/brake
pedal and engage
parking brake.
• Measure distance between brake oper-
ating arm and nut =A" on brake rod.
• If distance is other than 1-1/2", loosen
jam nut and turn nut "A" until distance
becomes 1-1/2".
Retighten jam nut
against nut =A".
• Road test tractor for proper stopping
distance as stated above.
Readjust if
necessary.
If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorized ser-
vice center/department,
With Parking Brake =Engaged"
Nut =A"
___ |
,/ mNut
_raUng
Arm
25

Advertisement

loading