Advertisement
I I1_
The operationof anytractorcan resultin foreignobjectsthrowninto the
I
[
-"-_'_- ] eyes, which can result in severe eye damage. Always wear safety glasses
I
_or
eye shields while operating your tractor or performing any adjustments or
repairs. We recommend a wide vision safety mask over spectacles,
or stan-
dard safety glasses.
HOW TO USE YOUR TRACTOR
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
TO SET PARKING
BRAKE
• Depress clutch/brake pedal into full
=BRAKE" position and hold.
• Place parking brake lever in =EN-
GAGED" position and release pressure
from clutch/brake pedal. Pedal should
remain in "BRAKE"
position. Make sure
parking brake will hold tractor secure.
Push-In to
Attachment Clutch
Choke
"Disen
Switch Pull Out To
Control
Tt_rottls/
Choke
Control
.Br--_a s _
Position
Position
Pedal =Drive" Knob
Position
Position
STOPPING
MOWER BLADES
• To stop mower blades, move attach-
ment clutch switch to =DISENGAGED"
position.
GROUND
DRIVE
• To stop ground drive, depress
clutch/brake
pedal into full "BRAKE"
po-
sition.
• Move gearshift
lever to neutral
(N) posi-
tion.
ENGINE
• Move throttle control to slow position.
NOTE:
Failure to move throttle control to
slow position and allowing engine to idle
before stopping may cause engine to
=backfire".
• Turn ignition key to "OFF" position and
remove key. Always remove key when
leaving tractor to prevent unauthorized
use.
• Never use choke to stop engine.
IMPORTANT:
Leaving the ignition switch
in any position other than "OFF" will cause
the battery to be discharged (dead).
NOTE:
Under certain conditions when
tractor is standing idle with the engine run-
ning, hot engine exhaust gases may
cause "browning"
of grass.
To eliminate
this possibility, always stop engine when
stopping tractor on grass areas.
_,
CAUTION:
Always stop tractor com-
pletely, as described above, before leaving
the operator's position; to empty grass
catcher, etc.
THROTTLE
CONTROL
Always operate engine at full throttle.
• Operating
engine at less than full throt-
tle reduces the battery charging rate.
• Full throttle offers the best bagging and
mower performance.
TO USE CHOKE
CONTROL
Use choke control whenever
you are start-
ing a cold engine. Do not use to start a
warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE
FORWARD
AND BACKWARD
The direction and speed of movement
is
controlled by the gearshift
lever.
• Start tractor with clutch/brake
pedal
depressed and gearshift lever in neutral
(N) position.
• Move gearshift lever to desired
posi-
tion.
• Slowly release clutch/brake pedal to
start movement.
IMPORTANT:
Bring tractor to a complete
stop before shifting or changing gears.
Failure to do so will shorten the useful life
of your transaxle.
TO ADJUST
MOWER
CUTTING
HEIGHT
The cutting height is controlled by turning
the height adjustment knob in desired
direction.
• Turn knob clockwise ((3) to raise cutting
height.
• Turn knob counterclockwise
(_) to
lower cutting height.
The cutting height range is approximately
1-1/2" to 4". The heights are measured
from the ground to the blade tip with the
engine not running.
14
Advertisement
