GE XL44 J2B915 Owner's Manual And Installation Instructions page 47

[] Replace the Power Cord (Optional) Continued
Perform this step only if the power cord shipped on the range does not match your wall receptacle.
[] 3-Wire Conduit Installation Option
[] I,ocate tile copper ground strap on tile
lower back of tile range.
] I,oosen tile upper center screw on tile
temfinal block.
[]
Slide tile open slotted
end of tile ground
strap under tile upper center screw on tile
temfinal block. Make sure tile gro/md strap
is all tile way against tile upper center screw
and tighten it in place.
[] Place tile gro/md plate (remoxed earlier)
over tile bottom of tile groined strap, press
them against tile range ti'ame and attach
them with tile gro/md screw (removed
ealtier).
[] Remo_e tile smfin relief clamp fl'om tile
bracket.
[]
,_ssemble tile squeeze connector (obtained
locally) matching tile diameter of yore"
conduit, in tile bracket hole. Insert the
conduit through tile squeeze connector:
Allow enough slack to easily attach tile wires
to tile temfinal block.
[]
NOTE:
Do not install tile conduit without a
squeeze connectoi:
Insert tile center bare wire (white/neutral)
fi ) throuoh tile bottom center temfinal
block opening. On certain models, the wire
will need to be inserted through tile grotmd
strap opening and then into tile bottom
center block opening. Insert tile two side
bare wire tips into tile lower left and tile
lower fight tem/inal block openings.
Tighten the scrmvs tmfil the wire is firefly
secm'e (approximately 20 inch-lbs.).
NOTE: Make sm'e the wire is completely
inserted into the temfinal block and a
sec/lI'e connection is made.
[] Secm'e tile squeeze connector in place in
tile bracket by, tightening, , tile S(lueeze ....
connector sci'ews.
NOTE: A LUMINUM WIRING:
,Muminmn building wire may be used but it must
be rated for tile correct ami)erage, and xoltage, to
i/lake connection.
Squeeze connector
Conduit /
Bracket
Wire tips _['_'-'m
Bracket
_----- Conduit
Ground strap
'I
Openslottedend
Wire used, location and enclosure of spfices, etc.,
must conform to good wiring practices and local
codes.
47