Craftsman 320.17559 Product Manual page 9

120V, 60HZ, AC only, 6 Amps ............................
1000 SFPM
Input:
Square Feet Per Minute
Sanding belt size 3"X 18"
..... ,,, , ,,,,,,,,, , ,,,,,
Protection class II
TURN ON/OFF THE BELT SANDER (Fig. 2)
1. Connect the plug to an
electrical outlet.
Fig° 2
2. Start the tool by squeezing
the on/off trigger switch.
3. Release the trigger to stop
the toolo
4. The lock-on button allows
the operator to keep the
belt sander running without
continuously holding the
trigger switch° While
squeezing the trigger
switch, depress the red
lock-on button, then
release both the switch and
the lock-on button,
5. To release the lock-on button, squeeze and release the trigger switch.
NOTE: The trigger cannot be released if you are pressing the lock-on button.
WARNING: DO NOT let familiarity with your belt sander make you
careless. Remember that a careless fraction of a second is sufficient to
cause severe injury.
17559 ManuaLRevised_07-0131 Page 9