Service Safety - Craftsman 320.17559 Product Manual

TOOL USE AND CARE continued
= DO NOT FORCE THE TOOL. Use the correct toot and blade for your application.
The correct tool and blade will do the job better and more safely at the rate for
which it is designed.
. DO NOT USE TOOL IF THE SWITCH DOES NOT TURN IT "ON" OR "OFR" Any
tool that cannot be controlled with the switch is dangerous and must be repaired.
o DISCONNECT THE TOOL before servicing (such as cleaning the dust-collector
box), changing accessories (such as sand paper), or storing the tool.
o STORE IDLE TOOLS OUT OF THE REACH OF CHILDREN and other untrained
people,
• NEVER LEAVE THE TOOL RUNNING UNATTENDED; turn the power off. Don't
leave the tool until it comes to a complete stop.
_,ALWAYS MAINTAIN TOOLS WITH CARE. Keep cutting tools sharp and clean.
Properly maintained tools with sharp cutting edges are less likely to bind and
are easier to control.
e CHECK FOR DAMAGED PARTS. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine that
it will operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, mounting, and any other conditions
that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced.
WARNING: Use of accessories that are not recommended for use with
this tool may create hazardous conditions,
USE RECOMMENDED ACCESSORIES, Consult the product manual for
recommended accessories. The use of improper accessories may increase
the risk of personal injury.
SERVICE SAFETY
• tf any part of this belt sander is missing or should break, bend, or fail in any
way; or should any electrical component fail to perform properly: ALWAYS shut
off the power switch and remove the plug from the power source, and have the
missing, damaged, or failed part replaced BEFORE resuming operation.
, All service that requires opening the tool MUST be performed only by a Sears
Service Center. All of the motor parts are important components of the double-
insulation system and MUST only be serviced by a Sears Service Center.
Service performed by unqualified personnel could result in a risk of injury.
,, When servicing a tool, ALWAYS use only identical replacement parts. Follow
instructions in the Maintenance Section of this manual. Use of unauthorized
parts or failure to follow Maintenance Instructions may create a risk of electric
shock or injury.
17559 ManuaLRevised_0743131 Page 6