GE JGB800 Owner's Manual & Installation Instructions page 54

(,t}
(J
ul
ul
{j
u_
ej
v
*.#J t_
_,:::i ¸::i:1:¸i:¸
:i i i;::i:iii:iii ::!i
:ILL ":_i: :
• . 4_ ¸
:!i::i f_!(:!_i
,i;i:_:_z;_!:;: !!!!/i:
0
Ul
E
ul
8
Before you call for service...
Troubleshooting Tips
Possible Causes What To Do
Excessivesmoking Excessivesoil,, o Touchthe Clear/Off pad. Open the windows to
rid the room of smoke Wait until the LOCKED DOOR
light goes off Wipe up the excesssoil and reset the
dean cycle
Oven door will not open Oventoo hot. t Allow the oven to coo! below locking temperature°
after a clean cycle Do not lock the door with the door latch except when
using tile self-cleanfeature
Oven not cleanafter a Oven controlsnot properlyset, • Seethe Usingthe self-cleaningupper oven section
clean cycle Oven was heavily soiled, * Cleanup heavy spitloversbefore starting the clean
cycle Heavily soiledovens may need to self-clean
again or for a longer period of time
"Door" appears in the Latch handle was moved to the • Hove the latch handle to the right only when setting
display {onmodels right but a program other than the self*cleaningcycle
with a door' latchl self-clean was selected.
"LOCKDOOR"flashes
in the display
LOCKED DOOR light
is on when you want
to cook
The self-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
wag to the right,,
• Closethe oven door and on models with a latch, move
the latch all the wag to the right
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperoture,
• Touch the Clear/Off pad Allow the ovento cool
and then, on models with a door latch, unlock the daD[
"F--" and a number or
letter"flashin the display
On models with a door"latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch°
,, The latch may have been moved, even if onlyslightly.
from the locked position,Hake surethe latch is moved
to the right as far as it will go
You have a function error code • Touchthe Clear/Off pod.Allow the oven to coot for
one hour.Putthe oven back into operation
If the function code repeats, • Disconnectall power to the range far5 minutes
and then reconnect power:If the function error
code repeats,call for service
The nickel racks (if so equipped) ° Apply a small amount of vegetable oil to a paper
were cleaned in a self-clean cycle., towel and wipe the edgesof the ovenrocks with
The gray porcelain-coated racks the paper towel Do not spray with Pam e or other
(if so equipped) were improperly lubricant sprays
cleaned,
Oven racks are
difficult toslide
"Probe" appears in This is reminding you to enter
a
° Enter' a probe temperature
the display {some models) probe temperature after' plugging
in the probe,
LOCshows in the
display
The Gas/ControlLockout feature • Be surethe surface burner controIs are turned OFF
is activate& Turn this feature off to usethe range Seethe Gas!Control
Lockoutsection
54