Advertisement
BLADE CLEANING
BRUSH
Refer to Figure 7.
•
Make sure that brush (Key No. 36) is in contact with
wheel to properly remove foreign particles from drive
wheel.
WARNING:
Make certain that unit is disconnected
from power source before attempting to service or
remove any component.
CLEANING
•
Keep machine and workshop clean. Do not allow
sawdust to accumulate on band saw.
•
Keep wheels clean. Debris on wheels will cause
poor tracking and blade slippage.
•
Keep mechanisms and threaded or sliding surfaces
clean and free of foreign particles.
•
Operate band saw with a dust collector to minimize
clean up.
LUBRICATION
•
The shielded ball bearings are permanently
lubricat-
ed and require no further lubrication.
•
Small amounts of machine oil can be applied to belt
tension mechanisms and threaded or sliding sur-
faces.
•
Occasionally apply a coat of automobile type wax to
table top to keep it slick and corrosion free.
KEEP BAND SAW IN REPAIR
•
If power cord is worn or cut in any way, have it
replaced.
•
Replace V-belt and blade when they are worn.
Replace any damaged or missing part.
•
Use parts list to order parts.
Advertisement
