In The Box - Craftsman 113.226423 Owner's Manual

: Unpacking A ndChecking C ontents ....... __._
.. 6
Mounting Belt and Disc Sander to Workbench . 7
Clamping Bell and Disc Sander to Workbench .. 8
Installing Timing Belt ...................... 9
Installing Pulley Cover .................... t0
Installing Sanding Disc Plate ............... 10
Installing Backstop ....................... 11
Installing Table Assembly .................. 12
Squaring Table Assembly .................. 13
Be!t Table Stop .......................... 18
Surface Sanding on Sanding Belt ........... 18
End Sanding on the Sanding Belt ........... 18
Sanding Curved Edges ................... 19
Maintenance .............................. 20
Lubrication ............................. 20
Troubleshooting ........................... 21
Recommended Accessories .................. 2t
Repair Parts .............................. 22
, n u, Jl ..#,€_ • . .....
unpacking and checking contents
TOOLS NEEDED
_ Model II3,226423 Belt and Disc Sander is shipped
complete in one carton.
__ Separate atl parts from packing materials and check
_=_--;- ' _ each item with illustration and "Table of Loose Parts."
7it6" W aENCH " (_) Make certain all items are accounted for, before dis-
I/2" WREI_H
3/4_ WRENCH
carding any packing material.
=
_: ts any parts are missing, do not attempt to assemble
PHILLIPS
tYPE
:
COMBINATION SQUARE MUST BETRUE the Belt and Disc Sander, plug in the power cord, or
;
SCREWDRIVER STRAIGHT EDGE O F turn the switch on until the missing parts are obtained
BOARD 3!4" THICK
and installed correctly.
: DRAWLIGHT THIS EDGEMUSTBE
:::
LINE:ON BOARD PERFECTLY STRAIGHT WARNING: For your own safety, never connect
: : i : A_ONG q'H S EOGE plug to power source outlet until all assembly steps
: : .... ; are complete and until you have read and under-
SHOULD BENOGAPOROVERLAP HEREWHEN
stood the entire owners manual.
SQUARE IS FLIPPED OVERtN DOTTED POSITION i:
: ; -- ..... ITEM TABLE OF LOOSE PARTS QTY.
A Belt and Disc Sander
Assembly ..................... !
B Owners Manual ................. 1
C Table Assembly ................. 1
D Sanding Plate .................. 1
E Sanding Disc ................... t
F Table Support Rod .............. I
G Bag Assembly Part #507303 .....
Containing the following parts:
Switch, Key ................... 1
Wrench, Hex "L" I/8 ............ 1
Backstop ..................... t
Washer, 1/4" . ................. 1
Bolt, Hex 1/4-20X1/2 ............ 1
Bolt, Hex 5/16-t8Xl ............ 2
Knob ........................ 1
Setscrew 1/4-20Xt/4" . .......... t
Screw 1/4-2OXl-3/4" . ........... 1
H Pulley Cover .................. !
J Timing Belt ................... t