Troubleshooting Tips - GE QuicksetcIII Owner's Manual

Before Vou Call For Service...
Troubleshooting Tips
Possible Causes What To Do
Storage drawer Rear'drawer support is • Reposition the drawer:,See the Storage Drawer
is crooked on top of the guide rail. Removal instructions in the Care and cleaning of
pour range section
Storage drawer Power cordmeg be • Repositionthe drawer and power cord Seethe
won't close obstructing drawer StorageDrawer Removalinstructionsin the (.-areand
in the lower back cleaningof the range section
of the range,,
Rear-drawer support is • Reposition the drawer See the Storage Drawer
on top of the guide raft Removal instructions in the Care and cleaning of the
range section
Oven wil! not self-dean The oven temperature is • Allow the oven to cool to room temperature and
too high to set a self-clean reset the controls
operation,
Oven controls improperig set° • See the Using the self-cleaning oven section
Oven door is not in the locked • Hake sure gou move the door batch handle all the
position, wag to the right
"Crackling" or This is the sound of the • This is normal,
"popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Touch the Clear/Offpad Open the windows to
during a clean cycle rid the room of smoke, Wait until the light on the
Self Clean pad goes off Wipe up the excess soil and
reset the cleon cgcle
Oven door will not Oven too hot. •Aitow the oven to cool below locking temperature,
unlock
Oven not clean after Oven controlsnot properlg set. ° See the Using the self-cleaningovensection
a clean cgcle
Oven was heavilg soiled. •Clean up heavgspitlovers before starting the clean
cgcle Heavilg soiled ovens may need to self-clean
again or for a longer' period of time
"F-" and a number You have a function • Disconnect all power to the range for at least
or letter flash error code, 30 seconds end then reconnect power If the function
in the display error code repeats, call far service
- On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch The latch mug hove been moved, if onlg
slightlg, flom the locked position, Hake sure the batch
is moved to the right as far as it will go Touch the
Clear/Offpad Allow the ovento cool for one hour,
Put the oven back into operation,
32