Craftsman 315.275062 Owner's Manual page 20

MAINTENANCE
DEPTH CONTROL KNOB ADJUSTMENTS
SeeFigure 34.
The depth control knob ts apdng loaded against hex nut to
prevent router motor from acddently separating from router
base,, ff depth control knob is turned too far up depth
adjustment rod, the spring wllf cause depth control knob to
pop off before hex nut., Do not remove hex not. _t should
remain on depth adjustment rod at all fJmes_Thts is espe-
cially important when using router upside down on a router
table.,
TO REPLACE DEPTH CONTROL KI_OB:
1, UNPLUG YOUR ROUTER.
2. Turn hex nut counterclockwise until 1/4 In. of threads
are remaining at the top of depth adjustment rod.
3. Place compression spring on top of hex nut as shown
in figure 34_
4,, Place deplh control knob on top of compression -qpdng
and align tabs on depth control knob with fiats on hex
nut.,
5 Carefully compress spring by pushing down on top of
depth control knob
6. With spring compressed, thread depth control knob
Clockwise onlo depth adjustment rod.
7 Turn depth control knob until desired depth of cut is
reached,
Do not replace depth control knob wilhoul compression
spring
DEPTH
CONTROL
DEPTH
ADJUSTMENT
ROD
COMPRESSION
1SPRtNG%
FLATS L,;
HEX NUT TABS Fig, 34
Page 20