GE EGR2000 Owner's Manual & Installation Instructions page 28

,0
m
h !
b .t
i/iiit{iiii{iiii{iii{iii{ii
i
m w.
i I
t
m
i
m
Care and cleaning of the range.
Burner Caps and Heads
NOTE:Beforeremovingthe burnercaps
and heads,remembertheirsize andlocation.
Replacethemin thesamelocationafter
cleaning.
Use a sewing needle or twist-tie
to unclog the small hole in the
burner head.
Burner caps
Lift offwhen cool. Wash burner caps
in hot, soap), water and rinse with clean
wateL You may scour with a plastic scoulJng
pad to remove burned-on food particles.
Burner heads
For proper ignition, make sure the
small hole in the section that fits over the
elecuode is kept open. A staving needle
or wire twist-tie works well m unclog it.
Theslitsin theburner headsmustbe keptclean
at all timesforan even,unhampered f lame.
Clogged or dirty burner ports or electrodes
will not allow the burner m operate properly.
Any spill on or around an electrode
must
be careflflly cleaned. Take care to not hit an
electrode with anything hard or it could
be damaged.
You should clean the burner caps and
burner heads routinely, especially after bad
spillovers, which could clog the openings
in the burner heads. Lift off when cool.
To remove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water for 20-30 minutes.
For more stubborn stains, use a toott_brush.
After cleaning
Before putting the burner caps and heads
back, shake out excess wamr and then d_T
them thoroughly by setting in a warm oven
for 30 mint]ms.
NOTE: Donot usesteelwoolor scouring powders
todean theburners.
Replacement
Replace burner heads over the electrodes
on the cooktop, in the correct locations
according to their size.
Onsome models:
Medium head sma head
and Cap andCap
Frontof range _
Largehead Largehead
and Cap and cap
Onsome models:
Medium head small head
,..L
r frne __
[orlto a g
• e g ha
and cap and cap
Make sure the slot in the burner head is
positioned over the electrode.
Replace the matching size caps onto the
heads.
Make sure that the heads and caps are
replaced in the correct locations.
NOTE:Onsome models,theburners areall the
samesizeandpower.
28