Advertisement
Available languages
Available languages
CRAFTSMAN
PROFESSIONAL
FULL WARRANTY
If this Craftsman Professional product fails due to a defect in material or workmanship
within three years from the date of purchase, return it
to any Sears store, Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement
if repair
proves impossible).
This warranty applies for only one year if this product is ever used for commercial or rental purposes.
This warranty
covers ONLY defects
in material
and workmanship.
Sears will NOT pay for:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
Preventive maintenance,
or repairs necessary due to improper fuel mixture, contaminated
or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
APPLICATIONS
On/Off Stop Control
As a trimmer:
Cutting grass and light weeds.
Edging
Decorative trimming around trees, fences, etc.
Shaft Grip
Shaft Housing
Throttle
Lockout
D-Handle
_,
Throttle
Primer Bulb
Control
Shoulder
Strap
Loop
Choke Lever
Fuel Cap
Rapid Rewind ®
Cutting
Head
Air Filter
Cover
Optional Hassle Free®
Cutting Head
PLUS Cutting Head
Starter
Shield
_
Rope Grip
Line Cutting
Blade
Electric
Start
Adapter
iNSTALL AND ADJUST THE D-HANDLE
1.
Place D-handle over the
shaft housing and onto
the bottom clamp (Fig. 1).
Place it a minimum of 6
inches (15.24 cm) from
the end of the shaft grip.
2.
Start screws with a large
Flat-head or T-25 Torx
Minimum
screwdriver. Do not
6 in.
tighten until you make the (15.24 cm)
handle adjustment.
Shaft Grip
Screws (4)
D-Handle
3.
While holding the unit in the operating position (Fig. 13), move
the D-handle to the location that provides you the best grip.
4.
Tighten the clamp screws
evenly, until the D-handle
is secure.
INSTALL THE SHOULDER
SUPPORT
1.
Put the shoulder support
on using the clip. (Fig. 2).
Fig. 1
Clamp
Fig. 2
Advertisement
