FujiFilm FINEPIX A500 Owner's Manual page 113

Connecting to PC
PC does not
recognize the
camera.
Cannot print with
PictBridge.
The USB cable (mini-B) is not correctly
connected to the PC or camera.
.D._ PICTBRIDGE is selected in
USB MODE in the SET-UP menu.
[_ DSC is selected in _" USB MODE
in the SET-UP menu.
Connecting to
)rinter
Set up the camera, and connect the USB
90
cable (mini-B) correctly.
Perform the below steps to cancel the
setting before selecting [_3_ DSC.
• Windows
_ The "New Hardware Found" wizard or
"Scanner and Camera" wizard appears.
If the wizard does not appear, proceed
to step (_.
_2 Click the [Cancel] button. 90
_3_Disconnect the camera from the PC.
• Macintosh
(1 The window for locating the driver appears.
If the window does not appear, proceed
to step "3_.
_2_Click the [Cancel] button.
_,3"Disconnect the camera from the Macintosh.
Select 2_ PICTBRIDGE.
79
• Others
Nothing happens
when pressing the
buttons on the
camera.
The camera no
longer works
correctly.
Camera operation
etc.
Camera malfunction may be caused
temporarily.
The batteries have run out.
Camera malfunction may be caused
temporarily.
Briefly remove the batteries or disconnect 15,
the AC power adapter. Then reload the 16,
batteries or reconnect the AC power 78,
adapter and try again. 101
Load new or fully charged batteries. 15,
17,99
Briefly remove the batteries or disconnect 15,
the AC power adapter. Then reload the
batteries or reconnect the AC power adapter 16,
78,
and try again. If you think the camera is 101
faulty, contact your FUJIFILM dealer.
=_
=-
113