Download Print this page

Craftsman 917.773744 Owner's Manual page 5

Wheeled wheedtrimmer 22 inch cut
Hide thumbs Also See for 917.773744:

Advertisement

Available languages

Available languages

Serial Number:
Date of Purchase:
Gasoline Capacity
/ Type:
1.6 Quarts (Unleaded
Regular)
Oil Type (API SG-SL):
SAE 30 (above 32°F); SAE 5W-30 (below 32°F)
Oil Capacity:
20 Ounces
Spark Plug (Gap: .020")
Champion
RJ2YLE
Trimmer Line Length:
18.75 Inches (0.155 Inch Diameter)
• The model and serial numbers will be found on a decal on the rear of the trimmer.
Record both serial number and date of purchase in the space provided above.
Read these instructions
and this manual in
its entirety before you attempt to assemble
or operate your new trimmer.
IMPORTANT: This trimmer is shipped WITH-
OUT OIL OR GASOLINE
in the engine.
Your new trimmer has been assembled
at the factory with the exception of those
parts left unassembled
for shipping
purposes.
All parts such as nuts, wash-
ers, bolts, etc., necessary to complete the
assembly
have been placed in the parts
bag. To ensure safe and proper operation
of your trimmer, all parts and hardware
you assemble must be tightened
securely.
Use the correct tools as necessary to
ensure proper tightness.
When right hand (RH) or left hand (LH) is
mentioned
in this manual, it means when
you are in the operating position (standing
behind the handle).
Loose Parts Packed Separately
HOW TO SET UP YOUR
TRIMMER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
1. Loosen handle knob enough to allow
upper handle to be unfolded from the
shipping position.
2.
Raise upper handle section into place on
lower handle and tighten handle knob.
3.
Remove handle padding holding trim-
mer head control bar to upper handle.
Your trimmer handle can be adjusted for
your trimming comfort.
Refer to "ADJUST
HANDLE" in the Service and Adjustments
section of this manual.
\\i\
Upper handle
LIFT UP
Bottle of oil
Trimmer
Lines (2) Sets
(0.155 diameter
x 18.75 inches long)
REMOVE
TRIMMER
FROM
CARTON
1. Remove loose parts included with trimmer.
2. Cut down two end corners of carton
and lay end panel down flat.
3. Remove all packing materials.
4.
Roll trimmer out of carton and check car-
ton thoroughly for additional loose parts.
Handle
knob
Lower
handle
5

Advertisement

loading