Frigidaire FAH14ER2T1 Use & Care Manual page 8

Air Conditioner FeatureS(cont n.ed)
SLEEP FEATURE:
DO THIS:
PRESS
SLEEP PAD
HGHT ON
YOU W_LL SEE:
The Sleep Mode can be selected with a Heating or Cooling Mode. Note: In this "MODE" the selected cooling temperature
will increase by 2 degrees F, 30 minutes after the mode is selected. The temperature will then increase by another 2
degrees F, after an additional 30 minutes. This new temperature wil! be maintained for 7 hours before it returns to the
originally selected temperature. If this Mode is selected with Heat, the set temperature will Decrease at the same time
pattern. This ends the "Sleep" MODE and the unit wil! continue to operate as originally programmed. The "Sleep" MODE
program can be cancelled at any time during operation by pressing "Sleep" MODE button.
CHECK F_LTER FEATURE:
LIGHT ON
YOU W_LL SEE:
DOTHmS:
PRESS TO RESET
Note: This feature is a reminder to clean theAir Filter (See Care and Cleaning) for more efficient operation and cooling. The
LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Clean Filter" button and
the light will go off.
REMOTE SENSING FEATURE (on some mode_s)
YOU W_LL SEE:
LIGHT Pulsing On
& Off Intermittently
DO TH_S:
PRESS SENSING
START BUTTON
Note: unit display show
"set" temperature
Note: remote display is
actua! temperature at
remote control only
Note: This feature can be activated from the remote control ONLY.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing start button.
The LIGHT on the unit contro! will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each
time it sends a signal. It will continue to send this signal unti! the feature is deactivated by pressing the remote sensing stop
button. If the unit does not receive the remote sensing signal during any 3 minute interval, the unit will keep to indicate the
remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY. The unit
display indicates the set temperature.