Important Safety Instructions; Operation Of Current Device - Frigidaire FAH14ER2T1 Use & Care Manual

Important Safety
Read a[[ instructions before using this air condit{oner.
Instructions
The power suppEy cord
with this air conditioner contains a
current detection device designed to
reduce the risk of fire.
Please refer to the section
"Operation of Current Device" for
details.
in the event that the power supply
cord is damaged, it cannot be
repaired it must be replaced with a
cord from the Product Manufacturer.
_Avoid fire hazard or
electric shock. Do not use an extension
cord or an adaptor plug. Do not remove
any prong from the power cord.
Grounding type
wail receptacle
/,,/,"oo oot, ° o.er
/-'
any circumstances
cut, remove,
orbypass t he
grounding prong .... /
device
For Your Safety
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance. Read product labels for flammability and other
warnings.
Prevent Accidents
To reduce the risk of fire, electrical shock, or iniury to persons when using your air
conditioner, follow basic precautions, including the following:
o Be sure the electrical service is adequate for the mode! you have chosen. This
information can be found on the serial plate, which is located either on the
side of the cabinet or behind the grille.
® If the air conditioner is to be installed in a window, you wil! probably want to
dean both sides of the glass first. If the window is a triple-track type with a
screen panel included, remove the screen completely before installation.
® Be sure the air conditioner has been securely and correctly installed
according to the separate installation instructions provided with this manual.
Save this manual and the installation instructions for possible future use in
removing or reinstalling this unit.
o When handling the air conditioner, be careful to avoid cuts from sharp metal
fins on front and rear coils.
Electrical Information
The complete electrical rating of your new room air conditioner is stated on the
serial plate. Refer to the rating when checking the electrical requirements.
e Be sure the air conditioner is properly grounded. To minimize shock and fire
hazards, proper grounding is important. The power cord is equipped with a
three-prong grounding plug for protection against shock hazards.
o Your air conditioner must be used in a properly grounded wall receptacle. If
the wall receptacle you intend to use is not adequately grounded or protected
by a time delay fuse or circuit breaker, have a qualified electrician install the
proper receptacle.
® Do not run air conditioner with outside protective cover in place. This could
result in mechanical damage within the air conditioner.
® Do not use an extension cord or an adapter plug.
READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER.
Operation of Current
Device
Plug in &
Press RESET
NOTE:Some plugs have
Buttons on the side
The power supply cord contains a current device that senses damage to the power
cord. To test your power supply cord do the following:
1. Plug in the Air Conditioner.
2. The power supply cord wi[[ have TWO buttons on the plug head. Press the
TEST button. You wi[[ notice a click as the RESET button pops out.
3. Press the RESET button. Again you wi[[ notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit.
NOTE:
€ Do not use this device to turn the unit on or off.
o Always make sure the RESET button is pushed in for correct operation.
o The power supply cord must be replaced if it fails to reset when either the
TEST button is pushed, or it cannot be reset. A new one can be obtained from
the product manufacturer.
® If power supply cord is damaged, it CANNOT be repaired. It MUST be
replaced by one obtained from the product manufacturer.