Table of Contents
Advertisement
Electrical
Information
These guidelines must be followed to ensure that safety
mechanisms in the design of this appliance will operate
properly.
Avoid fire hazard or electric
shock. Do not use an extension cord or an
adapter plug. Do not remove any prong
from the power cord.
Grounding type
wall receptacle
Do not, under
any
circumstances,
cut, remove,
or bypass the
grounding prong,
J
Power supply
cord with 3-prong
grounding plug
Refer to the serial plate for correct electrical rating.
The power cord of the appliance is equipped with a
three-prong grounding plug for protection against shock
hazards. It must be plugged directly into its own properly
grounded three-prong
receptacle, protected with a 15
amp time delay fuse or circuit breaker. The receptacle
must be installed in accordance with the local codes and
ordinances. Consult a qualified electrician. Receptacles
with Ground Fault Circuit Interrupters (GFCI) are NOT
RECOMMENDED.
DO NOT USE AN EXTENSION
CORD OR AN ADAPTER PLUG.
If the voltage varies by 10 percent or more, appliance
performance may be affected. Operating the appliance
with insufficient power can damage the motor. Such
damage is not covered under the warranty. If you suspect
your voltage is high or low, consult your power company
for testing.
To prevent the appliance from being turned off
accidentally, do not plug the unit into an outlet controlled
by a wall switch or pull cord.
DO NOT pinch, knot, or bend the power cord in any
manner.
Other Precautions
NEVER unplug the appliance by pulling on the power
cord. Always grip the plug firmly and pull straight out from
the receptacle.
To avoid electrical shock, unplug the appliance before
cleaning.
NOTE: Turning the control to "OFF" turns off the compressor but
does not disconnect power to other electrical components.
Caster
Installation
and Set-up
Inspection
for Damage
Inspect the underside of the cabinet and packaging for damage,
similar to what can be caused with a forklift. If hidden damage
is found after uncrating, immediately call the delivery carrier
and request an inspection. Retain all packaging and crating
materials until the inspection is complete.
Parts and Accessories
Check to make sure that you have received the box containing
all of the components
listed below.
A
Carriage Bolt (4)
D
Fixed Caster (2)
B
Lock Nut (4)
E
Hex Screw (10)
C
Swivel Caster (2)
A
B
Tools Needed
C
E
The following tools are required to assemble and install the
casters to the unit:
5/16", 3/8" and 9/16"
Adjustable Wrench
Phillips _
Socket or Open End
or Pliers
Screwdriver
Wrench
Uncrating
and Set=up
Remove carton and all loose parts from inside the unit.
1.
2.
Remove the rear access guard and place it and the
screws in a safe place for reassembly later.
3.
Using an assistant, carefully tip the unit onto its back and
rest on blocks to avoid damaging the condensate drain
hose and the plastic raceway that covers the evaporator
tubing on the back of the cabinet.
4.
Remove the four scews holding the wood skid to the
bottom of the unit using a 3/8" socket wrench. See Figure
1. Discard the wood skid and screws.
8.
6.
Remove and discard the two front brackets with leg
leveler using a 5/16" socket wrench. See Figure 1.
FOR GLASS DOOR MODELS ONLY - Remove bottom
door support bracket and screw opposite the door hinge
using a 3/8" socket wrench. See Figure 2.
Hide quick links:
Advertisement
Table of Contents
