Unpack Pressure Washer; Carton Contents - Craftsman 580.752090 Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you haveany problems with the assembly of your pressure
washer, pleasecatl the pressure washer helpline at
1o800o222o3136.
UNPACKPRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
CheckalI contents, if any parts are missing or damaged, calJ
the pressure washer hetpline at 1o808o222o3136.
* Main Unit
, Handle
, Accessory Tray
, High Pressure Hose
, Short High Pressure Hose
, Spray Gun
, NozzleExtensionwith Quick Connect Fitting
, HydroFoam
TM
Wash
. Oii Bottle
, Hose Reel Kit
, Parts Bag (which inciudes the foiiowJng):
, Operator's Manual
, Owner's Registration Card
, Safety Goggles
, Bagcontaining 3 multi-colored ProjectPro_'Nozzies
, HydroFoam
TM
Launcher
, HydroFoam
TM
Launcher & Wash instruction Sheet
, FreshStart Fuel Cartridge
, HandieFastening Hardware Kit (which includes):
, Wireform (I}
° Carriage Bolts (2)
, Plastic Knobs (3}
, Tree Ciips (4)
Becomefamiiiar with each piece before assembiing the
pressure washer, identify aii contents with the iiiustration on
page 6. if any parts are missing or damaged, caiJthe
pressure washer helpJineat 1-880-222-3t36.
ASSEMBLINGPRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. FilI out and send in registration card.
2. Attach handle and accessory tray.
3. Add oii to engine crankcase.
4. Attach hose reel.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun, hose reel and
pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attach quick connect ProjectPro_ nozzle to nozzle
extension.
Attach ttandle and Accesso_ Tray
1. Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
NOTE:it may be necessary to move the handie supports
from side to side in order to align the handle so it will slide
over the handie supports.
2. insert carriage bolts (A) througil holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
Insert spray gun holder wireform (A} through hole on
left side of handle (viewing from front of unit). Hoid
wireform in piace and attach a plastic knob (B) from
inside of unit. Tighten by hand.
4. Placeaccessory tray (A) over isoles (B) on handle
(viewing from front of unit). Push the tree clips (C} into
the holes until they sit fiat against the accessory tray.
5. Insert multi-colored ProjectPro _ nozzlesin spaces
provided in accessorytray. See How to Use Accessory
Tray.