Craftsman 580.752090 Operator's Manual page 15

Fellowthese instructions t o shaegePrejestPro ® nozzles:
1. PuiI back collar on quick-connect and pull current
ProjectPro_> nozzle off. Store ProjectPro _' nozzlesin
holder provided on the accessorytray.
WARNING
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underiying tissues, ieading to serious injury and
)ossibleamputation.
* NEVER exchange ProjectPro _ _ nozzles withoutlockingthe
trigger lock on the spraygun.
o DONOT twist ProjectPro < ' n ozzles while spraying.
.
Select desired ProjectPrd_ nozzle:
o Fordelicate rinse (iower pressure and higher flow),
for gentte cteaning of cars/trucks, boats, RV's, patio
furniture, iawn equipment, etc. select yellow
delicate ProjectPro_ nozzte.
For generalrinsing (medium pressureand medium
flow), idealfor most aiI purposecteaningsuch as
home siding, brick patios,wood decks, drivewaysand
sidewalks,garagefloors, etc., selectorangegeneral
ProjectPro _> nozzte.
For maximum rinsing (higiler pressure and lower
flow), for stubborn or hard to reachsurface such as
second story surfaces, paint removal, eli stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red max ProjectPro_'
nozzle,
3. Pull back on collar, insert selected ProjectPro_ nozzle
and releasecollar. Tug on ProjectPro_'nozzle to make
sure it is secureiy in piace.
4. For most effectivecleaning, keep ProjectPrd_ nozzle from
8 to 24 inches away from cleaningsurface. If you get the
nozzletoo close, you may damagethe cleaningsurface.
5. DONOTget closerthan 6 incheswhen cleaningtires.
Hew te 8se the HydreFeam
TM
Laancher
The quick-connect on the nozzleextension aliows you to
attach the HydroFoam
TM
iauncher. Usethe HydroFoam
TM
launcher to appiy HydroFoam
TM
wash or other project specific
cteaners to heip break down stubborn dirt and grime on a
variety of surfaces.
Follow these instructions to attash the HydreFearn
T M
lace€her:
1. Pull back collar on quick-connect and pull current
ProjectPrd_ nozzle off. Store ProjestPro_'nozzles in
holder provided on the accessopj tray,
2. Pull back on collar, insert HydroFoam
TM
launcher and
releasecollar. Tug on HydroFoam
TM
launcher to make
sure it is securely in place.
IMPORTANT:Also see the HydroFoam
TM
launcher and wash
instruction sheet for important instructions and uses.
Cteaning and Applying Detergent
A CAUTJe
Chemicalscan cause bodily injupj, and/or property damage.
_ EVER usecausticliquid with pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
rnanufacturers i nstructions.
15