Warranty - Craftsman 580.752090 Operator's Manual

Add Engine OiJ
1. Place pressure washer on a fiat, level surface.
2. Cleanarea around oii fiii and remove yeliow oii fiii cap.
NOTE:See Oil Recommendations in Maintenancesection.
Verify provided oii bottie is the correct viscosity for current
ambient temperature.
3. Using oii funnel (optional), siowiy pour contents of
provided oil bottle into oil fill opening.
improper treatment of pressure washer can damage it and
shorten its iife.
DONOT attemptto crankor startthe enginebeforeit hasbeen
properlyservicedwith the recommended o il. This may resultin
an enginefailure.
4. Replace oil fill cap and fully tighten.
Add Fuel
Fuel must meet these requirements:
Clean, fresh, unleaded gasoline.
o A minimum of 87 octane/87 AKi (91 RON). Higil altitude
use, see High Altitude.
o Gasoiinewith up to 10% ethanol (gasohoi) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
NOTICE
Avoid pressure washer damage.
Faiiureto foiiow Operator's Manuai for fuel
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fue! system from gum formation, mix in a fuel
stabiiizer when adding fuet. See Storage. Ali fuel is not the
same. if you experience starting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
WARNING
FueIand its vapors are extremely fiammabb and
explosive.
_l_ ire or explosion can cause severe burns or
death.
WHENADDmNG FUEL
o Turnpressure washerOFF and let it coolat least2 minutes
beforeremovingfuelcap. Loosencapslowly' t o relievepressure
in tank.
o Fillfuel tankoutdoors.
• DONOToverfilltank.Allowspacefor fue! expansion.
o If fuel spills,wait until it evaporates beforestartingengine.
• Keepfuelawayfrom sparks,openflames,pilot lights,heat,and
otherignitionsources.
o DONOTlight a cigaretteor smoke.
1. Cieanarea around fuel fiii cap, remove cap.
2. Siowiy add regular unleaded fuel (A) to fuei tank (B). Be
carefui not to overfiii. Aiiow about 15" (4 cm) (C) of tank
space for fuel expansion.
CAUTION! AIcohoI-blendedfuels (caiied gasoiloI, ethanoi or
methanol) can attract moisture, which leadsto separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems,the fueI system should be treated
with a fuel preserver or emptied before storage of 30 days or
longer, if adding a fuel preserver, fiii the fuei tank with fresh
fuel. if oniy partiaiiy filied, air in the tank wiii promote rue!
deterioration during storage, if fuet preserver is not used,
drain the fuei tank, start the engine and iet it run untii the fuel
fines and carburetor are empty. Use fresh fuel next season. See
Storagefor additionalinformation.
NEVERuseengine or carburetor cleaner products in the fuel
tank as permanent damage may occur.