Unpack Pressure Washer; Carton Contents - Craftsman 580.752150 Operator's Manual

Your p ressure washer requires some assembly and is ready
foruse onlyafter i t hasbeen properly serviced withthe
recommended oilandfuel.
Jf
you have any prohtemswith the assembly of your
pressurewasher, pmease call the pressurewasher hempline
at 1o800o222o3136.
UNPACK PRESSURE W ASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1=800=222=3136.
° Main Unit
° Handle
o Accessory Tray
° High Pressure Hose
, Spray Gun
o NozzleExtensionwith Quick Connect Fitting
, HydroFoam
TM
Wash
° Oil Bottle
, Parts Bag (which includes the following):
o Operator's Manual
, Owner's Registration Card
, Safety Goggles
o Bagcontaining 3 multi-coiored ProjectPro
TM
Nozzles
, HydroFoam
TM
Launcher
, HydroFoam
TM
Launcher & Wash Instruction Sheet
o FreshStart Fuel Cartridge
, HandieFasteningHardwareKit (which includes):
o Carriage Boits (2)
o Plastic Knobs (2)
, Tree Ciips (4)
Becomefamiiiar with each piece before assembling the
pressure wasiser, identify aii contents with the iiiustration on
page 6. if any parts are missing or damaged, calI the
pressure washer helpline at 1=808=222=3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer wJflneed assembly before
operation:
1. Fiii out and send in registration card.
2. Attach handle and accessory tray.
3. Add oii to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzleextension to spray gun.
8. Sebct/attach quick connect ProjectPro
TM
nozzleto nozzle
extension.
Attach Handle and Accesse_ Tray
1. Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handb align with holes
(C) on handle supports.
NOTE:it may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handb supports.
2. insert carriage bolts (A) through holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
3. Placeaccessory tray (A) over holes (C) on handle
(viewing from front of unit). Push the tree clips (B) into
the holes until they sit fiat against the accessory tray.
4. Insert multi-colored ProjectPro
TM
nozzlesand other
suppiied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.