Craftsman CTX 9500 Operator's Manual page 12

Attachment Lift Control Lever
When using the mower deck, lift the deck off the ground
while transporting to and from the job site. DO NOT
cut with the mower in the raised, transport position.
The attachment lift control lever raises and lowers
attachments that utilize the tractor's hydraulic lift cylinder.
Pushing the lever forward lowers the attachment while
pulling the lever back raises the attachment.
IMPORTANT NOTE - The attachment lift will not work
when the parking brake is engaged.
0 € e Information
rmd
0
Figure 3
Dashboard Display
A. FUEL LEVEL
Indicates the amount of fuel in the fuel tank. Left is empty;
right is full (Figure 3).
B. HOUR METER / CLOCK / SERVICE INDICATOR
Displays the clock, hour meter, and maintenance reminder.
The hour meter measures the number of hours the key has
been in the RUN position. The hour meter will flash an initial
oil change indicator at 5 hours, and a lubrication reminder
every 50 hours. These reminders display for approximately
two hours and will automatically reset themselves.
NOTE. The hour meter will register the passage of time
when the key is in the RUN position, even ff the engine is not
running. The hour meter has a serf contained power source
so the total hours are always visible.
C. SELECT BUTTON
Used to set the clock and reset the maintenance reminder.
D. SET BUTTON
Used to set the clock and reset the maintenance reminder.
E. PTO LIGHT
Indicates the PTO switch is in the ON position.
F. CRUISE CONTROL LIGHT
Indicates that the cruise control is engaged.
G. LOW OIL PRESSURE LIGHT
Indicates that the engine oil pressure is low. The light will
turn on when the tractor is first started and then go out. IF
THIS LIGHT TURNS ON WHILE THE TRACTOR IS IN USE,
TURN THE ENGINE OFF IMMEDIATELY. Contact Sears
Service.
H. LOW VOLTAGE LIGHT
Indicates that the electrical system voltage is low. The light will
turn on when the tractor is first started and then go out. IF THIS
LIGHT TURNS ON WHILE THE TRACTOR IS IN USE,
TURN THE ENGINE OFF IMMEDIATELY. Contact Sears
Service.
Functions
Display Total Running Hours - When the key switch is
first turned to the RUN position, all warning indicators will
light and the total running hours will be displayed. Be sure all
lights are functioning.
Display PTO Hours - Turn the key OFF, engage the PTO,
and turn the key to RUN (engine off).
12