Tools Required For Assembly; Operator's Position; Contents Of Hardware Pack - Craftsman 917.293401 Owner's Manual

"Yournew tiller has been assembled at the
factory with exception of those parts left
unassembled for shipping purposes. To
ensure safe and proper operation of your
tiller all parts and hardware you assemble
must be tightened securely. Use the cor-
rect tools as necessary to insure proper
tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(t) Utility knife
(1) Wire cutter
(1) Tire pressure gauge
(1) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION
When right or left hand is mentioned in
this manual, it means when you are in
the operating position (standing
behind tiller handles).
LEFT
FRONT
OPERATOR'S
POSITION
RIGHT
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(2) Hairpin Clips
(1) Carriage Bolt
3/8-16 UNC x 1 Gr. 5
(1) Cable Clip
(1) Pivot Bolt
3/8-16 UNC Grade 5
(1) Flat Washer
13/32 x 1 x 11 Ga.
(1) Handle Lock Lever "_
5