Bag Of Parts; Tools Required For Assembly; Operator's Position; Contents Of Hardware Pack - Craftsman 917.292301 Owner's Manual

Your new tiller has been assembled at the
factory with exception of those parts left
unassembled for shipping purposes, To
ensure safe and proper operation of your
tillre all parts and hardwa[e you assemble
must be tightened securely. Use the correct
tools as necessary to insure proper tight-
nesso
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utility knife
(t) Pair of pliers
(2) 1/2" wrenches
OPERATOR'S POSITION
When dght or left hand is mentioned in
this manual, it means when you are in
the operating position (standing behind
tiller handles).
Front
Left Right
Operator's Position
CONTENTS OF HARDWARE PACK
(t) Manual
(2) Lock
Washers 5/16
@ G
__--_" (2) Flange Locknuts (2) Hex Nuts
5/i 6-18 UNC 5/t 6-18
-k_J-
(1) Plastic
Cable
Clip
(1) Bofife Engine Oil
(2) Hex Bolts
5/16_18 x 1:1/4
(2) Carriage Bolts 5/16-18 UNC x 2-3/8 Gr. 5
5