To Start Engine With A Weak Battery; To Replace Headlight Bulb; Interlocks And Relays; To Replace Fuse - Craftsman EZ3 944.609050 Owner's Manual

15.5 hp electric start 42" mower 6 speed transaxle lawn tractor
Table of Contents

Advertisement

SERVICE AND ADJUSTMENTS
TO START ENGINE WITH A WEAK BA'I-rERY
SEE FIG. 29)
CAUTION:
Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries.
Always
wear eye protection
when around batteries.
TO REPLACE HEADLIGHT BULB_
Raise hood.
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulbinholder and push bulbholder securely
back into theholeinthebacksideofthegrill.
Close hood.
If your battery is too weak to start the engine, it should be
recharged.
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
YOUR TRACTOR IS EQUIPPED WITH A
12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE
MUST
ALSO
BE A 12 VOLT
NEGATIVE
GROUNDED SYSTEM.
DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO A'I-I'ACH JUMPER CABLES -
Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis.
Connect one end of the BLACK cable to the NEGA-
TIVE (-) terminal of fully charged battery.
Connect the other end of the BLACK cable to a good
CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
BLACK cable first from chassis and then from the fully
charged battery.
RED cable last from both batteries.
POSITIVE TERMINAL
NEGATIVE TERMINAL
CABLES
CHARGED
BA'I-rERY
POSITIVE TERMINAL
NEGATIVE TERMINAL
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring.
See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE
FUSE
Replace _,ith 30 amp automotive-typeplug-infuse. The
fuse holderislocatedbehindthe dash.
TO REMOVE
HOOD AND GRILL ASSEMBLY
(See Fig. 30)
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Gr&sp hood at sides, tilt toward
engine and lift off of tractor.
To replace, reverse above procedure.
HEADLIGHT
WIRE
CONNECTOR
FIG. 30
FIG. 29
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents