ii
ii,i,
,i
,
..............
TO LEVEL MOWER
HOUSING
Adjust the mower whife tractor is parked on tevet ground or
dfiveway_
Make sure tires are properly
inflated (See
PRODUCT
SPECIFICATIONS'
on page 3)
If tires are
over or under inflated, you will not properly adjust your
mower.
SIDE-TO-SIDE
ADJUSTMENT
(See Figs_18 and19) -
•
Raise attachment lift lever to its highest position.
•
Measure height from bottom of deck curl to ground
level at front corners of mower, Distance "A" should be
the same
.
If distance "A" needs to be changed, snap out access
hole cover on left side of tractor above footrest°
•
To raise teft side of mower, loosen nut "B" and tighten
nut "C".
•
To lower left side of mower, loosen nut "C" and tighten
nut "B".
.
When distance "A" is equal, securely tighten nuts "B"
and "C".
•
Replace access hole cover.
FRONT-TO-BACK
ADJUSTMENT
(See Figs 20 and 21) -
To obtain the best cutting results, the mower housing
should be adjusted so that the front is approximately 3/8" to
1/2" lower than the rear when the mower is in its highest
position_
Check adjustment on right side of tractor°
Measure dis-
tance "D" at front and rear flanges of mower housing as
shown,
•
To lower front of mower turn nut"E" counterclockwise
on both front links an equal number of turns.
•
When distance "D" is 3/8" to 1/2" lower at front than
rear, tighten nuts "F" against trunnion on both front
links
o
To raise front of mower, loosen nut"F" from trunnion on
both front links Turn nut "E" clockwise on both front
links an equal number of turns.
.
When distance "D" is 3/8" to 1/2" lower at front than
rear, retighten nut "F" against trunnion on both front
links,
IMPORTANT:
WHEN
ADJUSTING
FRONT
LINK
TRUNNIONS,
ALWAYS ADJUST BOTH
EQUALLY
SO
MOWER WILL STAY LEVEL SIDE-TO-SIDE.
•
Recheck side-to-side adjustment,
LIFT LEVER
(RAISED
POSITION)
BOTTOM
BOTTOM
OF CURL
OF CURL
\
GROUND LINE
FIG. 18
SIDE TO SIDE
ADJUSTMENT _
[))
_
/
TRUNNION_NUT
"C'
NUT"B"
FIG. 20
NUT "F"
.E•
FRONT LINKS
TRUNNION
FIG. 19
FIG. 21
19