To Add, Reprogram Or Change A Keylessentry Pin - Craftsman 139.53920DM Owner's Manual

To Add, Reprogram or Change a Keyless Entry PIN
NOTE: Your new KeylessEntry must be programmed to operateyour garage door opener.
USINGTHE "LEARN" BUTTON
1. Press and releasethe "learn" button
on the motor unit. The learn LED
will glow steadily for 30 seconds.
.
Within 30 seconds, enter a four
digit personal identification number
(PIN) of your choice on the keypad.
Then press and hold the ENTER
button.
.
Releasethe button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
I /
One ButtonC/ose:Openercan be closed by pressing only the
ENTERbutton if the one button close feature has been activated.
This feature has been activated at the factory. To activate or
deactivate this feature press and hold buttons 1 and 9 for 10
seconds. The keypad will blink twice when the one button close is
active. The keypad will blink four times when one button close is
deactivated.
Tochangean existing, knownPIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and hold
the # button.
The opener light will blink twice. Releasethe # button.
2. Press the new 4-digit PIN you have chosen, then press ENTER.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press ENTER.The door should
move.
Toset a temporaryPIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours or
number of accesses,this temporary PIN expires and will no longer
open the door. It can be used to closethe door even after it has
expired. To set a temporary PIN:
1. Press the four buttons foryour personal entry PIN
(not the last temporary PIN), then press and hold the _, button.
The opener light will blink three times. Releasethe button.
2. Press the temporary 4-digit PIN you have chosen, then press
ENTER.
The opener light will blink four times.
3. To set the number of hoursthistemporary PIN will work, press
the number of hours (up to 255), then press _,.
OR
3. To set the number of timesthis temporary PIN will work, press
the number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN has
been learned.
Test by pressing the four buttons for the temporary PIN, then
press ENTER.The door should move. If the temporary PIN was set
to a certain number of openings, remember that the test has used
up one opening. To clear the temporary password, repeat steps
1-3, setting the number of hours or times to 0 in step 3.
36