Advertisement
Electrical
Requirements
Now start...
Because of the weight and size of
the wine cellar, two or more
people are required to install it.
All four leveling legs must contact
the floor to support and stabilize
A. Prepare wine cellar
for installation
!
Electrical Shock Hazard
Electrical ground is required.
Do Not ground to a gas pipe.
Do Not change the power supply
cord plug. If it does not fit the
outlet, have a proper outlet
installed by a qualified electrician.
Do Not have a fuse in the neutral
or grounding circuit.
Do Not use an extension cord.
Check with a qualified electrician if
you are not sure wine cellar is
properly grounded.
It is the customer's responsibility
to contact a qualified electrical
installer; and to assure that the
electrical installation is adequate
and in conformance with all
national and local codes and
ordinances.
Failure to follow these instructions
could result in death or electrical
shock.
!
WARNING
Injury Hazard
the weight of the wine cellar and
contents.
Failure to follow these
instructions could result in injury.
1.
Remove tape, grille and
literature/parts packages from wine cellar.
Wipe interior with damp cloth to remove
any dust.
WARNING
If codes permit and a separate
grounding wire is used, it
recommended that a qualified
electrician determine that the
grounding path is adequate.
3-prong grounding-
type wall receptacle
3-prong
grounding
plug
power
supply cord
grounding
prong
A 120-volt, 60-Hz, AC-only, 15- or 20-
ampere, fused, electrical supply is
required. A time-delay fuse or circuit is
recommended. It is recommended that
a separate circuit serving only this wine
cellar be provided.
This wine cellar is equipped with a
power supply cord having a 3-prong
grounding plug. To minimize possible
shock hazard, the cord must be plugged
into a mating 3-prong, grounding-type
wall receptacle, grounded in accordance
with all national and local codes and
ordinances.
Important: Observe all governing codes
and ordinances.
Do not lift the wine cellar by the door
handle.
Slide wine cellar onto cardboard or
hardboard before moving to prevent
floor damage.
Do Not touch the sharp condenser fins.
2.
Put on protective gloves.
Advertisement
