Advertisement
,_
WARNING: To prevent accidental starting or
electrical shock that could cause possible
serious personal injury, assemble all parts to
your saw before connecting it to power supply.
Saw should never be connected to power supply
when you are assembling parts, making
adjustments, lubricating, installing or removing
blades, cleaning, or when not in use.
•
This saw is very heavy. To avoid back injury, get
help when lifting the saw.
•
Carefully lift saw from the carton and place it on
a level work surface.
•
Remove pack of 4 extra blades and owner's
manual from the carton.
_,
WARNING: If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so cou_l result in possible
sedous personal injury.
•
Do not discard the packing materials until you
have carefully inspected the saw, identified all
parts, and satisfactorily operated your new saw.
Note: If any parts are damaged or missing, do not
attempt to plug in the power cord and turn the switch
on until the damaged or missing parts are obtained
and are installed correctly.
Your scroll saw table was covered with a lubricant and
a cover at the factory to prevent rust. Remove the
plastic cover and clean with a soft cloth and a small
amount of mineral spirits, or rubbing alcohol. DO not
use acetone, gasoline, or lacquer thinner. These are
dangerous and may also damage plastic and rubber
parts of your saw.
Your scroll saw comes completely assembled. A
package of 4 extra blades and an owner's manual are
included with your saw.
The following tools (not included) are needed for
adjustments and alignment:
• Small Combination Square
• Adjustable wrench
• Phillips Screwddver
SMALL
COMBINATION
SQUARE
PHILLIPS SCREWDRIVER
Fig. 2
The following labels are on the scroll saw with locations indicated.
A,
CRAFTSMAN °
24.in. Scroll Saw
2.Speed
8
Advertisement
