Installation; How To Remove The Mower Housing; How To Install The Mower Housing - Craftsman 502.270210 Owner's Manual

13.5 hp. electric start 30" mower / mulcher 5 speed rear engine rider
Table of Contents

Advertisement

sERvicE
AND ADJUSTMENT
HOW TO REPLACE
THE MOTION
DRIVE
BELT
REMOVAL
4,,
5.
6.
1.
Remove the mower housing. See the instructions on "How To
Remove The Mower Housing"°
2., Completely push the clutch/brake pedal forward and engage
the parking brake,,
3o Try to pull the motion drive belt off the drive pulley,, ff the belt
guides are too close to the drive pulley, loosen the belt
guides (Figure 37),
Remove the motion drive belt from the idler pulley,,
Putl the motion drive belt toward the front of the unit.
Remove the motion drive belt from the stack pulley.
If
necessary, loosen the belt guide at the stack pulley, A correct
replacement part or assistance is available from an authorized
service center in your area,
INSTALLATION
Slide the motion drive best between the stack pulley and the
belt guider install the motion drive belt on the top pulley of the
stack pulley. Make sure the "V" side of the belt is against the
pulley (Figure 36).,
2,
Slide the motion drive belt between the belt retainer and idler
pulley° Make sure the flat side of the motion drive belt is against
the idler pulley Also, make sure the belt is not twisted.
3.
Instal] the motion drive belt around the drive pulley.,
4,,
Make sure the motion drive belt is inside all the belt guides.
5.
Make sure all the belt guides are tight,,
6,
Before you use the unit, check the adjuslment of the clutch,,See
the instructions "How To Check And Adjust The Clutch".
7_
tnsta[I the mower housing. See the instructions "How To Install
The Mower Housing",,
Motion Drive Belt
Side Against Pulley)
) j
Putley
Figure 36
Stack Pulley
BellRelainer
Belt Guide
Drive Pulley
0
Figure 37
F-98668
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents