Cutting Height Adjustment; Mower Removal And Installation - Craftsman Remote Controller Operator's Manual

Cutting Height Adjustment

The cutting height adjustment switch controls the mower
cutting height. The cutting height is adjustable between
1.75" (4,4 cm) and 4.0" (10,2 cm).
Press the adjustment switch (A, Figure 15) forward to
lower the mower deck, backward to raise the mower
deck.
The slot in the cutting height indicator ( ) indicates the
cutting height of the mower deck.
B
A
Figure 15. Cutting Height Adjustment
24

Mower Removal and Installation

NOTE: Perform mower removal and installation on a
hard, level surface such as a concrete floor.
WARNING
After lowering the mower cutting height, engage
parking brake, turn off the mower blades, turn the
ignition switch to STOP, and remove key before
attempting to install or remove the mower.
Removal
1. Turn the mower blades OFF, put the ground speed
control levers in START/PARK position, engage the
parking brake, turn the ignition OFF, and wait for all
moving parts to stop.
2. Pivot the front wheels forward.
3. Use the mower belt lever (A, Figure 16) to release
belt tension. Remove the mower belt ( ) from engine
pulley (C).
A
¿½ËÈ» »ÃÅÌ» ·Äº ÄÉʷ ÅÍ»È »ÂÊ
4. Turn the ignition switch from OFF to RUN without
starting the engine.
5. Use the mower cutting height switch to raise the
mower deck.
6. Place 4x4 wood blocks under the front and rear lip of
the mower deck to securely support it.
7. Use the mower cutting height switch to fully lower the
mower so that is it resting on the 4x4 wood blocks.
8. Turn the ignition switch to OFF and remove the key.
9. Remove the hair pin clips (A, Figure 17) and wash-
ers ( ) that secure the rear lift arms (C). Separate the
rear lift arms from the mower deck.
B
C