Troubleshooting - DieHard 200.71224 Owner's Manual

Performance problems often can be corrected by the user. Please read through this
chart for a possible solutions to common problems.
PROBLEM POSSIBLE CAUSE SOLUTION
Indicator lights are lit in The charger may be Return to place of
an errat c manner not defective, purchase for a
] explained in the "Using replacement.
Your Battery Charger"
section.
The red abort light always
flashes before the battery
is charged.
Engine crank time is less
than specified.
The green full charge light
turns on a few minutes
after connecting to the
battery.
This will happen if the
battery did not reach full
charge within 24 hours.
May be due to a very large
battery or a bank of
batteries requiring more
than what a 15 Amp
charger can deliver within
24 hours. The battery may
also be bad.
Starter motor may be
drawing more than 100
Amps.
The battery may be fully
charged or recently
charged leaving the
battery voltage high
enough to make the
charger think the battery
is fully charged.
Reset the charger by
unplugging it or briefly
disconnecting the negative
battery clip. Select the
desired charge rate and
battery type again, if
necessary,
Charge the battery at the
15 Amp rate for 10 to 15
minutes then crank the
engine.
If the battery is in a vehicle
turn the headlights on for a
few minutes to reduce the
battery voltage and try
charging again:
For information about troubleshooting, call toll-free from anywhere in the
U.S.A. 7 am to 4:30 pm CT Monday through Friday.
1-800-SEARS-64 (1-800-732-7764).
14