Stop Switch - Craftsman 358.794774 Operator's Manual

KNOW YOUR BLOWER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
MULCHING BLADES
Your blower is equipped with mulching blades as a standard feature. When using
the vacuum attachment, the mulching blades automatically reduce debris at a
ratio of up to 16:1.
Throttle Position Lever
Throttle igger
Starter
Rope
Fuel Mix
Fill Cap x4,
f
Primer
Bulb
Upper Vacuum Tube
\
Elbow Tube
STOP Switch
J Spark Plug
Upper Blower Tube
Start Lever
Vacuum Handle
Lower Vacuum Tube
Lower Blower Tube High-
Speed
Nozzle
STOP SWITCH
The STOP switch is used to stop the
engine. To stop the engine, push and
hold the STOP switch in the STOP posi-
tion until the engine stops.
THROTTLE TRIGGER
The THROTTLE TRIGGER is used to se-
lect the desired engine speed.
THROTTLE POSITION LEVER
The THROTTLE POSITION LEVER is de-
signed to allow setting engine speed
during blower use only. To avoid caus-
ing damage to the unit, DO NOT at-
tempt to use the throttle position lever
during vacuum use.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate primer bulb by
pressing it and allowing it to return to
its original position.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Activate
the starting system by moving the start
lever to the START position. DO NOT
squeeze the throttle trigger until the
engine has started and runs. After the
engine starts, allow the engine to
warm-up 10-15 seconds, then fully
squeeze the throttle trigger to deacti-
vate the starting system (start lever re-
turns to RUN position).
-9-