How To Use Your Trimmer; Engine Speed; Trimmer Head Drive Control; To Adjust Trimming Height - Craftsman 917.773704 Owner's Manual

Wheeled weedtrimmer 6.0 horsepower 22 inch cut
Table of Contents

Advertisement

Available languages

Available languages

The operation
of any trimmer
can result in
foreign
objects
being thrown
into the
eyes, which can result in severe eye
damage.
Always
wear safety glasses
or
eye shields
while operating
your trimmer
or performing
any adjustments
or repairs.
We recommend
standard
safety glasses
or a wide vision safety
mask worn over
spectacles.
HOW TO USE YOUR TRIMMER
ENGINE SPEED
The engine
speed is controlled by a
throttle
located on the side of the upper
handle.
FAST position
is for starting
and
normal trimming.
SLOW
is for light
trimming
and fuel economy.
STOP is for
stopping
the engine.
@
/
TRIMMER
HEAD DRIVE CONTROL
Your trimmer
is equipped
with a trimmer
head drive control
bar which will require
the operator
to be positioned
behind the
trimmer
handle to operate
the trimmer.
• Trimmer
head rotation
is controlled
by
holding the trimmer
head control
bar
down to the handle.
• Trimmer
head rotation
will stop when
the control bar is released.
TO ADJUST TRIMMING
HEIGHT
_CAUTION:
Stop the engine and wait
for all moving parts to stop. Disconnect
spark plug wire from spark plug and
place wire where it cannot come in
contact with plug.
The height of cut can be set to six (6)
different positions ranging from 1-1/2
inches to 3 inches.
Recommended
cutting
height for the average
yard is 2 inches.
1. To adjust trimming
height,
push in the
locking
plate tab and move trimmer
head up or down to desired
position.
2.
Release
tab and be sure head is
locked into one of the six (6) height
positions.
Adjustable
Trimmer
Head
Lockinc
Plate Tab
1
BEFORE STARTING ENGINE
ADD OIL
Your trimmer is shipped without oil in the
engine. For type and grade of oil to use,
see "ENGINE"
in the Maintenance
section
of this manual.
• 1= CAUTION:
DO NOT overfill engine with
oil, or it will smoke on startup.
1.
Be sure trimmer is level and area
around oil fill is clean.
2.
Remove oil dipstick from oil fill spout.
Make sure that rim of spout is clean.
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents