Trimmer; Tires; Trimmer Line; To Cut Line To Proper Length - Craftsman 917.773704 Owner's Manual

Wheeled weedtrimmer 6.0 horsepower 22 inch cut
Table of Contents

Advertisement

Available languages

Available languages

TRIMMER
Always
observe safety rules when perform-
ing any maintenance.
TIRES
• Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
• Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
TRIMMER LINE
For best results, replace trimmer lines
when they have worn to half their original
length. Use .155 inch diameter
trimmer
line. Cut new trimmer line length to 18-3/4
inches.
After new line is installed on
trimmer head, check all lines so they do
not vary more then one (1) inch in length.
This is important to make sure the trimmer
head is balanced
and will not vibrate
abnormally.
AWARNING:
Use only the specified
trimmer line. Do not use other materials
such as wire, string, rope, etc. Wire can
break off during trimming and become a
dangerous
missile that can cause serious
injury.
TO CUT LINE TO PROPER
LENGTH
NOTE: Trimmer
line pre-cut to proper
length is available
for this unit; see the
Repair
Parts section
of this manual.
If trimmer
line is purchased
in bulk, it must
be cut to 18-3/4
inches
before using.
Use
the built-in
length
guage
as follows:
1. From front of trimmer,
place the end of
spooled
trimmer
line at the mark on
the side of the debris
shield as shown.
2.
Wrap trimmer
line around
front of
chassis
cover to other side and cut at
the "22" mark (your unit's width of cut).
TO REPLACE
TRIMMER
LINE
1. Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2.
Remove worn trimmer line from line
carrier plate.
3.
Fold new, cut to length, trimmer line in
half and insert folded
end through
carrier plate opening to back side of
retainer clip.
4.
With folded end of line at back side of
retainer clip, pull line outward until
line is fully seated under the retainer
clip.
5.
Repeat on other side of carrier plate.
6.
Check all lines to be sure they are the
same length.
7.
Reconnect
spark plug wire to spark
plug.
Trimmer
line
cover
Carrier pl_e
opening
WRAP
LINE
_.ROUND
Debris
New
shield
End of
trimmer
mark
spooled line
line
clip
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents