Removing The Blade; Led Worklight; "Live Tool Indicator" Light; Operation - Craftsman 320.17234 Operator's Manual

TOOL-LESS BLADE INSTALLATION cont. (Fig, 5, 6 and 7)
5 Pull on blade to make sure 1he blade ts securely locked in place_
6 Attach the clear chip shield into its mounting slots and snap the shield down to its
proper position.
NOTE: For use with both "T" and "U" shanked blades, I
L
!
Z_ CAUTION:
Once the blade is installed in the saw, it is always exposed.
There is no lower blade guard. Use caution when handling the saw so that the
blade does not catch clothing, skin, etc, Each time you set the saw down take
care not to bend the blade, Always set saw down on its side when blade is
installed.ALWAYS remove blade when saw is not being used.
REMOVING THE BLADE
1o Unplug the saw.
..................
L_ WARNING:
ALWAYS unplug saw from the power source before
changing blades or making any adjustments. Failure to unplug the saw could
result in accidental starting which can cause serious personal injury,
2 Follow steps 1 through 4 on the tool-less blade installation (see pages !3 and I4).
3oCarefully remove the blade (or change the biade).
4_Reattach the clear chip shield and snap it down to its proper position_
i NOTE: When storing your saw, ALWAYS remove the cutting blade.
LED WORKLIGHT (Fig.B)
"Yoursabre saw has an LED worklight that
turns "ON" automaticafly when the saw is
plugged into a power source, The light helps
provide easy visibility of the cutting line.
"LIVE TOOL INDICATOR" LIGHT (Fig. 9)
Your saw has a "Live Tool Indicator" green
light that turns "ON" automatically when
the saw is plugged into a power source.The
light is Iocated on both sides of the base of
the trigger -switch handle near the body of
the saw.
14