Controls; How To Use Your Edger - Craftsman 358.797450 Operator's Manual

OPERATION
HOW TO USE YOUR EDGER
STOPPING YOUR ENGINE
• Move on/off switch to the "Off" position.
• If engine does not stop, move choke lever to fult choke
position.
CONTROLS (Fig. 5 & 6)
THROTTLE TRIGGER
• The throttle tdgger allows for variable contmt of
engine speed.
, The throttle trigger is actuated by the index finger on
your right hand.
CHOKE
• The choke is set by rotating the choke lever fully for
cold or refueted engine starts.
PRIMER BULB
• The primer bulb is used to circulate fuel to the carbu-
retor.
• The primer bulb is activated by pressing on it with
your thumb.
BULB
DEPTH CONTROL LEVER
• Controls the cutting depth of the blade.
• The Depth control lever is operated by moving it for-
ward or backwardto set the desired cutting depth.
TO SET EDGING DEPTH:
° Move the depth control lever rearward for half depth
edging.
• Move the depth control lever forward for full depth
edging.
DEPTH ADJUSTING WHEEL
° The depth adjusting wheel is spring loaded to remove
the blade from the cut when the unit is not in use.
WHEEL
ADJUSTMENT
CONTROL
DEPTH
WHEEL
Figure 6
CHOKE
Figure 5
-9-