Test Print; Ip Address Setup - Oki C9650dn Network And Configuration Manual

> Setup by HTTP
Launches the default browser in your environment to
access the selected printer's web page.
> Setup by TELNET
Launches the TELNET application in your environment to
access the selected printer's TELNET port.
NOTE
The TELNET application is not included as part of the print
server package. Install the TELNET package on to your
system. For further information, see your Windows manual.
> Reset
Resets the selected network interface card.
>

Test Print

Prints the network summary details (see
>

IP Address Setup

Sets the static IP address of the network interface card
manually. If you only use TCP/IP and the print server has
not yet been configured, occasionally it may not be
displayed on AdminManager. You can configure the IP
address of the print server by this function.
(a) Enter the Ethernet Address (MAC Address) and the
IP Address, then click OK.
NOTE
The Ethernet (MAC) Address is displayed under "General
Information" on the network summary printout (see
page 11).
(b) AdminManager asks whether you want to initialise
the network interface card or not. Select Yes.
NOTE
Even if you select No here, the IP address that you set can be
used after turning the printer OFF and ON. The requirement
to turn your printer OFF and ON is dependent on the network
interface card.
Using adminmanager standard setup > 42
page 11).