Oki C9600hdn Software Installation Manual page 3

Network Installation
Windows (cont'd)
2 Connect the Ethernet Interface
1. Switch off the printer and computer.
2. Remove the protective cover from the network connector on
the printer.
3. Connect the Ethernet cable between the print and the
Ethernet hub.
For more information, see the Print Server User's Guide
on CD2.
NOTE
3 Assign an IP address to the printer
If you are not using DHCP, you need to obtain an IP Address
from your network Administrator and enter it using the front
panel:
1. Confirm that the printer displays Ready to print .
∇
until Admin Setup displays.
2. Press
ENTER
3. Press .
4. Enter the password.
∆ ∇
Press either or
Hold down the key more than two seconds to fast forward.
ENTER
Press to proceed to the next figure.
ENTER
5. Press again after completing the password.
∆
until Network Setup displays.
6. Press
ENTER
. Slot1: 100/10 Base displays.
7. Press
ENTER
8. Press .
∇
until IP Address displays.
9. Press
ENTER
10. Press .
∆ ∇
11. Press either or
Hold down the key more than two seconds to fast forward.
ENTER
12. Press to proceed to the next character.
13. Repeat steps 11 through 12 to set all digits.
14. Press and repeat steps 9 through 13 to set the "subnet
Mask" and "Gateway Address."
ONLINE
until Ready to print displays.
15. Press
3
to enter the first figure of the password.
to set the first figure of the IP address.