HP XP20000/XP24000 Reference Manual page 13

Table 6 SNMP Information Tab (continued)
Item
System Group
Trap Test
Apply
Cancel
Description
Allows you to add, delete or change SNMP system group
information. If system group information has already been
registered, the registered information displays. To register
the system group information, the Extension SNMP check
box must be selected. When you register system group
information, select Apply. System group information is as
follows:
Name: Connected storage system name. Remote Web
Console users can change the device name. You can
use up to 180 alphanumeric characters for a device
name. You cannot use the following: ", \, ;, :, ,, *, ?,
<, >, |, /, ^, &, %, . You can use a space in the middle
of the device name, but not before and after and a
space before or after the device name.
The device name is required to use SNMP Agent. Make
sure to document the device name, because settings
will be cleared when SVP is replaced.
Contact: Contact information such as personnel and
telephone numbers where you can inquire about the
connected storage system. Remote Web Console users
can change contact information in Modify mode. Enter
contact information using up to 180 alphanumeric
characters (ASCII codes), except for some symbols, such
as ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can
also use a space, except before and after contact
information.
A contact name is required to use SNMP Agent. Make
sure to document the contact name, because settings
will be cleared when SVP is replaced.
Location: Location of connected storage system. Remote
Web Console users can change device locations with
the modify mode. You must enter a device location using
up to 180 alphanumeric characters (ASCII codes). You
can use a space, except for before and after the
location. You cannot use some symbols, such as ", \,
;, :, ,, *, ?, <, >, |, /, ^, &, and %.
The device location is required to use SNMP Agent.
Make sure to document the device location, because
the settings will be cleared when SVP is replaced.
Executes test report of the trap to the community registered
in the disk storage system.
Operation in Modify mode is required to use this button.
Operation authority is required as well.
Implements settings made on this window.
Cancels settings made on this window.
SNMP Information Tab 13