Remote Console Pc And Lun Configuration Manager Installation - HP Surestore Disk Array 12h - And FC60 Configuration Manual

Remote Console PC and LUN Configuration Manager Installation

10
Fabric
Connect the disk array port to the F-port of the fabric switch. Connect the host adapter
to the FL-port of the fabric switch.
Disk Array FC Port
The Fibre Channel topology parameters for each disk array Fibre Channel port depend
on the type of device to which the disk array port is connected. Determine the topology
parameters supported by the device, and set your topology accordingly. The type of
disk array port is also important. See "Configuring the Disk Array Fibre Channel
Ports" (page 16).
The user or HP service representative can install the remote console PC and HP
Surestore LUN Configuration Manager XP. You will use the LUN Configuration
Manager software on the remote console PC to set the host modes for the disk array
ports and configure the Fibre Channel ports. For instructions on installing the LUN
Configuration Manager software, see the product manual:
HP Surestore LUN Configuration Manager XP: User's Guide
If the LUN Configuration Manager software is not installed, the HP service
representative can use the SVP of the disk array to configure Fibre Channel ports.
Please contact your HP account team for further information on Fibre Channel
configuration services.
hp surestore disk array xp operating system configuration guide: SGI IRIX